load 4 by 6 inch (10 by 15 cm) photo paper
The following procedure describes how to load 4 by 6 inch (10 by 15 cm) photo
paper into your HP Officejet.
Note:
For the best results, use a recommended type of 4 by 6 inch (10 by
15 cm) photo paper. For more information, see
recommended papers
on
page 16. In addition, for best results, set the paper type and paper size
before printing. For more information, see
set the paper type
on page 17
and
set the paper size
on page 17.
Tip:
Help prevent rips, wrinkles, curled or bent edges by storing
all media flat in a resealable bag. Extreme changes in temperature
and humidity might result in curled media that does not work well
in the HP Officejet if the media is not stored properly.
1
Remove all paper from the input tray.
2
Lift the output tray and slide a stack of photo paper with the glossy (print)
side down completely forward and to the far right side of the input tray
until it stops. Position the long edge of the photo paper against the long
edge of the input tray.
Note:
If the photo paper you are using has perforated tabs, load the photo
paper so that the tabs are closest to you.
3
Lower the output tray and slide the paper-width guide against the stack of
photo paper (do not bend the photo paper with the paper-width guide).
Make sure the stack of photo paper fits under the tab of the paper-width
guide.
hp officejet 5500 series
chapter 2
16
load or
iginals & paper